GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Daewoo 🢒 2009 🢒 Lacetti (Global Delta) 🢒 Body Repair 🢒 Collision Repair 🢒 Front Bumper Impact Bar Replacement

Removal Procedure

    Warning: Refer to Approved Equipment for Collision Repair Warning in the Preface section.

    Warning: Refer to Glass and Sheet Metal Handling Warning in the Preface section.

  1. Disable the SIR System. Refer to SIR Disabling and Enabling.
  2. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection.
  3. Remove all related panels and components.

    4. Object Number: 2027923 Size: SH
  4. Remove the 8 front bumper impact bar bolts (1).

    5. Object Number: 2027924 Size: SH
  5. Cut the front bumper impact bar left and right.
  6. Locate and mark all factory welds.

    7. Object Number: 2027925 Size: SH
  7. Drill all factory welds.

    8. Object Number: 2027926 Size: SH
  8. Remove the remaining parts of the front bumper impact bar.

Installation Procedure

    Object Number: 2027927 Size: SH
  1. Position the front bumper impact bar on the vehicle.

    2. Caution: Refer to Fastener Caution in the Preface section.


    Object Number: 2027923 Size: SH
  2. Install the 8 front bumper impact bar bolts (1) and tighten to 110 N·m (74 lb ft).

    3. Note: Use only the original front bumper impact bar bolts. Replace bolts if damaged.

  3. Paint the repaired area. Refer to Basecoat/Clearcoat Paint Systems.
  4. Install all related panels and components.
  5. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection.
  6. Enable the SIR system. Refer to SIR Disabling and Enabling.