GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 1998 🢒 Venture 🢒 Body and Accessories 🢒 Bumpers 🢒 Rear Bumper Fascia Replacement

Rear Bumper Fascia Replacement Olds

Removal Procedure

Tools Required

J 38778 Door Trim Pad and Garnish Clip Remover

  1. Open the lift gate.

    2. Object Number: 314051 Size: SH
  2. Use the J 38778 in order to remove the push-in retainers from the upper and lower rear bumper fascia.
  3. Remove the screws at the right and left wheel well from the rear bumper fascia.
  4. Remove the rear bumper fascia splash shield. Refer to Rear Bumper Fascia Splash Shield Replacement .
  5. Remove the palnut from the rear bumper fascia outer retainer.
  6. Remove the rear bumper fascia from the vehicle.

Installation Procedure

    Object Number: 314055 Size: SH
  1. Align the rear bumper fascia to the rear bumper fascia outer support.

    2. Object Number: 314057 Size: SH
  2. Align the rear bumper fascia outer retainer to the body.
  3. Install the palnut to the rear bumper fascia outer retainer.

    4. Tighten
    Tighten the palnut to 2 N·m (18 lb in).


    Object Number: 314051 Size: SH
  4. Install the push-in retainers to the upper and lower rear bumper fascia.
  5. Install the screws at the right and left wheel well to the rear bumper fascia.

    6. Tighten
    Tighten the screws to 3 N·m (26 lb in).

  6. Install the rear bumper fascia splash shield. Refer to Rear Bumper Fascia Splash Shield Replacement .
  7. Close the lift gate.

Rear Bumper Fascia Replacement Pontiac

Removal Procedure

Tools Required

J 38778 Door Trim Pad and Garnish Clip Remover

  1. Open the lift gate.

    2. Object Number: 314053 Size: SH
  2. Use the J 38778 in order to remove the push-in retainers from the upper and lower rear bumper fascia.
  3. Remove the screws at the right and left wheel well from the rear bumper fascia.
  4. Remove the palnut from the rear bumper fascia outer retainer.
  5. Remove the rear bumper fascia from the vehicle.

    6. Object Number: 314064 Size: SH
  6. Remove the rear bumper fascia reflectors. Refer to Rear Bumper Fascia Reflector Replacement .

Installation Procedure

    Object Number: 314055 Size: SH
  1. Align the rear bumper fascia to the rear bumper fascia outer support.

    2. Object Number: 314059 Size: SH
  2. Align the rear bumper fascia outer retainer to the body.
  3. Install the palnut to the rear bumper fascia outer retainer.

    4. Tighten
    Tighten the palnut to 2 N·m (18 lb in).


    Object Number: 314061 Size: SH
  4. Install the push-in retainers to the upper and lower rear bumper fascia.
  5. Install the screws at the right and left wheel well to the rear bumper fascia.

    6. Tighten
    Tighten the screws to 3 N·m (26 lb in).


    Object Number: 314064 Size: SH
  6. Install the rear bumper fascia reflectors. Refer to Rear Bumper Fascia Reflector Replacement .
  7. Close the lift gate.