Important: Before performing the PSD re-initialization procedure, inspect for DTCs
by performing the Diagnostic Mode 1. Refer to Diagnostic Modes.
Perform the PSD re-initialization procedure when any of the following
conditions exist:
| • | The PSD is inoperative. |
| • | The vehicle battery is reconnected after being disconnected. |
| • | The vehicle battery is recharged due to a low or discharged battery
condition. |
| • | The RADIO fuse (located in the underhood accessory wiring junction
block) is reinstalled or replaced. |
| • | You exit any of the Diagnostic Modes. Refer to Diagnostic Information
and Procedures for more information. |
Use the following procedure in order to re-initialize the PSD:
- Enable the overhead console PSD lockout switch (pressed position).
- Manually open the sliding door completely.
- Manually close and fully latch the sliding door.
- Remove the RADIO fuse for 30 seconds.
- Reinstall the RADIO fuse.
- Wait 10 seconds.
- Disable the PSD lockout switch (released position).
- Press and release the PSD open/close switch (overhead console
or B-pillar). Allow the PSD to open completely.
- Press and release the PSD open/close switch.
- Repeat Step 8 and Step 9. Inspect for proper PSD
operation.
