GM Service Manual Online
For 1990-2009 cars only
Makes
🢒
Chevrolet
🢒
2007
🢒
TrailBlazer - 4WD
🢒
Preface
🢒
Cautions and Notices
🢒 Grille Replacement
Grille Replacement TrailBlazer
Removal Procedure
Use a flat-bladed tool in order to release the clips that retain the grille to the headlamp housing panel.
Remove the grille from the vehicle.
Installation Procedure
Install the grille to the vehicle.
Align the retaining clips on the grille with the slots in the headlamp housing panel.
Fully install the retaining clips into the headlamp housing panel.
Grille Replacement Rainier
Removal Procedure
Use a flat-bladed tool in order to release the clips that retain the grille to the headlamp housing panel.
Remove the grille from the vehicle.
Installation Procedure
Install the grille to the vehicle.
Align the 8 retaining clips on the grille with the slots in the headlamp housing panel.
Fully install the retaining clips into the headlamp housing panel.
Grille Replacement Envoy
Removal Procedure
Use a flat-bladed tool in order to release the clips that retain the top of the grille (2) to the headlamp housing panel.
Lift the grille (2) out of position.
Release the quick-connect (4) on the headlamp washer supply hose.
Remove the grille from the vehicle.
Place the grille on a clean, prepared surface.
Release the quick-connects (3) on the headlamp washer nozzle hoses.
Spread the retaining tabs (1) on the grille in order to release the headlamp washer nozzle.
Remove the headlamp washer nozzle from the front of the grille.
Remove the headlamp washer hose (4) from the grille.
Installation Procedure
Important:
Install the quick-connect end first.
Install the headlamp washer nozzle through the front of the grille.
Push the washer nozzle (2) inward until fully seated in the retaining tabs (1).
Install the headlamp washer supply hose (4) to the grille.
Connect the quick-connects (3) to the headlamp washer nozzles.
Position the grille to the headlamp housing panel.
Position the grille (2) onto the headlamp housing panel (1) such that the lower locating tabs (3) are properly aligned.
Connect the quick-connect (4) on the headlamp washer supply hose.
Align the upper locating tabs of the grille (2) with the slots in the headlamp housing panel (1).
Install and fully seat the retaining clips into the body.