- Install the oil pump strainer (2) and a new O-ring to the lower cylinder block. Secure the oil pump strainer using 2 bolts.
- Apply a continuous bead of silicon sealant GM P/N 12346240 (Canadian P/N 10953536) (1), or an equivalent, to the engine oil pan mating surface.
- Install the engine oil pan.
- Install the engine oil drain plug and the gasket.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the oil pump strainer to 11 N·m (97 lb in).
Use the following components to secure the engine oil pan:
| • | Sixteen bolts |
| • | Two nuts |
Tighten
Tighten the engine oil pan bolts and the nuts to 11 N·m
(97 lb in).
Tighten
Tighten the engine oil drain plug to 35 N·m (26 lb ft).
