GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2009 🢒 Spark 🢒 Steering 🢒 Power Steering 🢒 Power Steering Pump Replacement

Removal Procedure

    Object Number: 1225419 Size: SH

    Note: The power steering pump in this vehicle is not serviceable. A faulty pump must be replaced.

  1. Remove the front passenger side headlamp.
  2. Disconnect the supply line pipe hose (1).
  3. Disconnect the pressure line pipe fitting (2).

    4. Object Number: 1225420 Size: SH
  4. Remove the pump drive belt. Refer to Power Steering Pump Belt Replacement.

  5. Disconnect the power steering pressure switch connector (1) and remove the bolts (2).

    6. Object Number: 1225421 Size: SH
  6. Remove the power steering pump and bolt (1).

Installation Procedure

    Caution: Refer to Fastener Caution in the Preface section.


    Object Number: 1225423 Size: SH
  1. Install the power steering pump with the bolt (1) and tighten to 18-22 N·m (13-16 lb ft).
  2. Connect the power steering pressure switch connector.
  3. Install the pump drive belt. Refer to Power Steering Pump Belt Replacement.

    4. Object Number: 1225425 Size: SH
  4. Install the rear bracket adjusting (2) and power steering bolt (3).
    5. • Tighten the rear bracket adjusting bolt to 20-24 N·m (15-18 lb ft).
    • Tighten the power steering bolt to 20-24 N·m (15-18 lb ft).
  5. Connect the pressure line pipe to the outlet connection (1) on the steering pump and tighten the pressure line pipe fitting to 21-35 N·m (16-26 lb ft).
  6. Install the front passenger side headlamp.
  7. Refill the pump with new fluid and bleed the air from the system. Refer to Power Steering System Bleeding.
  8. Inspect for leaks. If leaks are found, correct the cause of the leak and bleed the system.