- Measure the front toe.
Specification
The front toe must be between 0 degrees and 0.333 degrees.
- If the front toe is not within the specification, separate the clamps from the steering gear boots.
- Loosen the right and the left tie rod end lock nuts.
Note: The right and left tie rods must be equal in length.
- Turn the right and the left tie rods to align the toe.
Specification
Adjust the front toe to 0.167 degrees.
Caution: Refer to Fastener Caution in the Preface section.
- Tighten the tie rod end lock nuts to
45 N·m (33 lb ft).
- Install the clamps to the steering gear boots.