Special Tools

J 34028 Inner Tie Rod Wrench

1. Remove the engine shield, if equipped. Refer to Engine Shield Replacement.
2. Remove the steering linkage outer tie rod. Refer to Steering Linkage Outer Tie Rod Replacement.



3. Remove the steering linkage inner tie rod (1) from the relay rod using wrench J 34028  (2).

1. Remove all traces of oil, grease, or other contaminants.
2. Clean the threads of the steering linkage inner tie rod with denatured alcohol or the equivalent and allow to dry.
3. Apply red LOCTITE™ threadlocker, GM P/N 12345493 (Canadian P/N 10953488) to the threads of the steering linkage inner tie rod.

Caution: Refer to Fastener Caution in the Preface section.




4. Install the steering linkage inner tie rod (1) to the relay rod using wrench J 34028  (2) and tighten to 100 N·m (74 lb ft).
5. Install the steering linkage outer tie rod. Refer to Steering Linkage Outer Tie Rod Replacement.
6. Install the engine shield, if equipped. Refer to Engine Shield Replacement.
7. Adjust the front toe. Refer to Wheel Alignment - Steering Wheel Angle and/or Front Toe Adjustment.