Listed below are the vehicle inspections and services that should be made by either the owner or a qualified technician at the frequencies indicated to help ensure the following:
| • | Proper safety of the vehicle. |
| • | Dependability of the vehicle. |
Complete any necessary repairs at once. Use the proper fluids or lubricants whenever adding to the vehicle. For information on fluids and lubricants to use when service is required, refer to Fluid and Lubricant Recommendations .
At Least Monthly
Tire Inflation Check
Check the tire pressure when the tires are COLD. Maintain tire pressures indicated on the Tire Placard on the driver's door of the vehicle, or refer to Tire Inflation Pressure Specifications .
At Least Twice A Year
Restraint System Check
Make sure the safety belt reminder light and all the belts, buckles, latch plates, retractors, anchorages are working properly. Look for any other loose or damaged safety belt system parts. If anything is seen that might keep a seat belt system from doing it's job, have it repaired. Have any torn or frayed seat belts replaced. For seat belt diagnosis information, Refer to Restraints.
Also look for any opened or broken supplemental inflatable restraint (SIR) covers. For SIR diagnosis information, Refer to Restraints.
The SIR system does not need regular maintenance.
Weatherstrip Lubrication
Clean the weatherstrip surface, and then apply a thin film of silicone grease, GM P/N 12345579 or equivalent, using a clean, dry cloth.
Wiper Blade Check
Inspect wiper blades for wear or cracking. Replace blade inserts that appear worn or damaged, or that streak or miss areas of the windshield. Refer to Wiper Blade Assembly Replacement in Windshield Wiper/Washer System.
At Least Once A Year
Key Lock Cylinders
Lubricate the key lock cylinders with the proper lubricant. For information on the proper lubricant to use, refer to Fluid and Lubricant Recommendations .
Body Lubrication
Lubricate all body door hinges and latches, including the following:
| • | The hood |
| • | The rear compartment lid |
| • | The fuel door |
| • | The headlamp pivot points |
| • | The console door |
| • | The I/P passenger compartment |
For information on the proper lubricants to use, refer to Fluid and Lubricant Recommendations .
More frequent lubrication may be required when exposed to a corrosive environment.
Brake Transmission Shift Interlock (BTSI) Check
Caution: When performing this check, the vehicle could move suddenly. Personal injury or property damage may result. Make sure there is enough room around the vehicle, in case the vehicle does move. Be ready to apply the regular brake immediately should the vehicle begin to move.
Turn the ignition to RUN. Without applying the regular brakes, try to move the transmission shift lever out of PARK with normal effort. If the shift lever moves out of PARK, the brake transmission shift interlock (BTSI) needs service. For wiring schematic information, Refer to Steering.
Steering Column Park Lock Check
While parked and with the parking brake set, try to turn the ignition key to LOCK in each shift lever position.
The key should come out only in the LOCK position. For wiring schematic information, Refer to Steering.
Parking Brake and Drive Motor Check
Caution: When performing this check, the vehicle could begin to move. Personal injury or property damage may result. Make sure there is enough room in front of the vehicle, in case the vehicle begins to roll. Be ready to apply the regular brake immediately should the vehicle begin to move.
To check the parking brake's holding ability: with the engine running and transmission in NEUTRAL, slowly remove foot pressure from the regular brake pedal. Do this until the vehicle is held by the parking brake only.
To check the drive motor's holding ability: with the key ON, shift to PARK, then release all brakes.
Underbody Flushing
At least every spring, use plain water to flush any corrosive materials from the underbody. Take care to thoroughly clean any areas where mud and other debris can collect.
