Step
| Action
| Normal Result(s)
| Abnormal Result(s)*
|
1
|
- Get into the vehicle and close the door.
- Turn the ignition to the RUN position.
|
| • | The fasten seat belt indicator lights. |
| • | The audio alarm sounds. |
| • | The light and the alarm quit after approximately 10 seconds. |
|
| • | The fasten belts lamp does not light and the alarm does not sound
with the seat belt unbuckled. |
| • | The fasten belts lamp does not light but the alarm does sound
with the seat belt unbuckled. |
| • | The fasten belts lamp lights but the alarm does not sound with
the seat belt unbuckled. |
|
2
|
- Turn the ignition to the OFF position.
- Fasten the seat belt.
- Turn the ignition to the RUN position.
|
| • | The fasten seat belt indicator does not light. |
| • | The audio alarm does not sound. |
| The fasten belts lamp lights and/or the alarm sounds with the seatbelt
buckled.
|
3
|
- Turn the ignition to the OFF position.
- Leave the keys in the ignition and open the driver's door.
| The audible warning sounds as long as the driver's door is open.
| The key in the ignition alarm does not sound with the key in the ignition
and the driver's door open.
|
4
|
- Close the driver's door.
- Remove the key from ignition.
- Turn the headlamps to the HEAD or the PARK position.
- Ensure that the interior lights dimming switch is not at maximum
dimming.
- Open the driver's door.
| The audible warning sounds as long as the headlamps are ON and the door
is open.
| The lamps on the warning alarm do not sound with the ignition OFF and
the lamps ON.
|
5
| Drive the vehicle and turn
ON either turn signal for at least 0.75 miles.
| The audible
warning sounds with the flashing of the turn signal.
| The turn signal
reminder does not sound.
|
6
| Perform Steps 1-5.
| The audio alarm sounds
properly in each situation.
|
| • | The audio alarm does not operate at all. |
| • | The audio alarm sounds continuously. |
|
* Refer to the appropriate symptom diagnostic
table for the applicable abnormal result.
|
