GM Service Manual Online
For 1990-2009 cars only

Service of the powertrain control module (PCM) should normally consist of either replacement of the powertrain control module (PCM) or electrically erasable programmable read only memory (EEPROM) programming. If the diagnostic procedures call for the PCM to be replaced, the PCM should be inspected first to see if the correct part is being used.

Notice: Turn the ignition OFF when installing or removing the PCM connectors and disconnecting or reconnecting the power to the PCM (battery cable, PCM pigtail, PCM fuse, jumper cables, etc.) in order to prevent internal PCM damage.

Important: Remove any debris from the PCM connector surfaces before servicing the PCM. Inspect the PCM module connector gaskets when diagnosing/replacing the PCM. Ensure that the gaskets are installed correctly. The gaskets prevent contaminant intrusion into the PCM.

Removal Procedure

    Caution: Unless directed otherwise, the ignition and start switch must be in the OFF or LOCK position, and all electrical loads must be OFF before servicing any electrical component. Disconnect the negative battery cable to prevent an electrical spark should a tool or equipment come in contact with an exposed electrical terminal. Failure to follow these precautions may result in personal injury and/or damage to the vehicle or its components.

    Notice: In order to prevent internal damage to the PCM, the ignition must be OFF when disconnecting or reconnecting the PCM connector.

  1. Disconnect the negative battery cable.

  2. Object Number: 352488  Size: SH
  3. Move the PCM retention bar and retainer away from the PCM.

  4. Object Number: 352489  Size: SH
  5. Remove the PCM from the PCM mounting bracket.

  6. Object Number: 66513  Size: SH
  7. Disconnect the PCM electrical connectors.

Installation Procedure

  1. Remove the replacement PCM from the packaging.
  2. Check the service number in order to make sure the service number is the same number as the defective PCM.

  3. Object Number: 66513  Size: SH

    Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  4. Connect the PCM electrical connectors.
  5. Tighten
    Tighten the PCM electrical connectors screws to 8 Nยทm (71 lb in).


    Object Number: 352489  Size: SH
  6. Slide the PCM retainer into the PCM bracket slots.

  7. Object Number: 352488  Size: SH
  8. Pull the PCM retention bar into position.