Important: A new SRS coil assembly will be pre-centered.
Improper alignment of the SRS coil assembly may damage unit causing
an inflatable restraint malfunction.
- Verify the following before centering the SRS coil assembly:
| • | The wheels on the vehicle are straight ahead. |
| • | The block tooth (1) of the steering shaft assembly is in
the 12 o' clock position. |
| • | The ignition switch is in the "LOCK" position. |
- If the front (4) of
the SRS coil has a centering window (3) and no spring service lock
on the back side (1), perform the following steps:
| 2.1. | Hold the coil assembly with the face up. |
| 2.2. | Rotate the coil hub clockwise until the coil ribbon can no longer
travel. |
| 2.3. | Rotate the coil hub slowly, counter clockwise until the centering
window appears yellow and both arrows (2) line up. This is center position. |
| 2.4. | While holding the coil hub in center position, align the SRS coil
assembly with the horn tower and slide onto steering shaft assembly. |
