For 1990-2009 cars only
Removal Procedure
- Raise the vehicle. Support the vehicle.
- Remove the oil pan and filter. Refer to Automatic Transmission Fluid Filter and Seal Replacement .
- Remove the oil feed pipes. Refer to Oil Feed Pipes Replacement .
- Remove the three lo and the reverse band servo cover bolts, the servo and the spring.
- Disassemble, clean and inspect the lo/reverse servo assembly. Refer to Automotive Transmission Transaxle Unit Repair.
Caution: Refer to Vehicle Lifting Caution in the Preface section.
Installation Procedure
- Assemble the lo/reverse servo. Refer to Automotive Transmission Transaxle Unit Repair Manual.
- Install the lo and the reverse band servo cover bolts.
- Install the oil feed pipe. Refer to Oil Feed Pipes Replacement .
- Install the oil filter and pan. Refer to Automatic Transmission Fluid Filter and Seal Replacement .
- Lower the vehicle.
- Connect the negative battery cable.
- Fill the transmission. Refer to Fluid Capacity Specifications .
- Inspect the transmission fluid level. Refer to Transmission Fluid Check .
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the bolts to 12 N·m (106 lb in).
