Circuit Description
The brake switch is used to indicate brake pedal status to the transmission control module (TCM). The brake switch is a normally open switch. Applying the brake pedal closes the switch, supplying voltage to the TCM. Releasing the brake pedal interrupts voltage to the TCM.
Important: If the brake pedal was applied prior to or during the connection of the scan tool to the vehicle, a P0703 will be set. If the system is operating normally, the code will then be deleted once the brake pedal is applied with the scan tool connected.
This DTC is stored at start-up. If the TCM receives a brake switch signal after start-up, the DTC will be stored in memory.
Conditions for Setting the DTC
| • | Brake switch stuck to closed |
| • | Brake switch wiring harness shortage to ground |
| • | Immediately after the above condition occurs |
Action Taken When the DTC Sets
| • | No lamp control required, but diagnostic information should be stored immediately when malfunction is detected. |
| • | The TCM assumes that the brake light is always active. |
Conditions for Clearing the Hold Lamp/DTC
Using a scan tool can clear history DTCs.
Diagnostic Aids
| • | Inspect the poor wiring harness connection for TCM connectors and transaxle wiring connectors. |
| • | Inspect the improperly formed or damage terminals. |
Step | Action | Values | Yes | No |
|---|---|---|---|---|
1 | Perform the Diagnostic System Check. Is the check complete? | -- | Go to Step 2 | |
2 |
Did the brake switch status change from Applied to Release? | -- | Go to Step 3 | Go to Step 4 |
3 | With the scan tool still connected. Turn the ignition OFF. After turning the ignition OFF, turn ignition ON, engine OFF. Using the scan tool, check for transmission DTC's Did the DTC P0703 reset? | -- | Go to Step 4 | Go to Step 17 |
4 | Inspect the EF13. Is the fuse blown? | -- | Go to Step 5 | Go to Step 6 |
5 | Replace the fuse. Is the action complete? | -- | System OK | -- |
6 |
Is the resistance approximately equal to the specified value? | 0 ohms | Go to Step 8 | Go to Step 7 |
7 | Repair the open circuit between the C102 connector and the brake switch connector. Is the action complete? | -- | System OK | -- |
8 |
Is the voltage within the specified value? | 11-14 V | Go to Step 9 | Go to Step 10 |
9 | Repair the short to power between the C102 connector and the brake switch connector. Is the action complete? | -- | System OK | -- |
10 |
Is the resistance approximately equal to the specified value? | 0 ohms | System OK | Go to Step 11 |
11 | Repair the open or short to ground between brake switch connector and TCM. Is the action complete? | -- | System OK | -- |
12 |
Is the voltage within the specified value? | 11-14 V | Go to Step 13 | Go to Step 14 |
13 | Repair the short to power between the brake switch wiring connector and TCM. Does the system function correctly? | -- | System OK | Go to Step 14 |
14 | Using a ohmmeter, check the brake pedal switch for proper operation. Refer to Automatic Transmission Controls Schematics Is the switch operating correctly? | -- | Go to Step 17 | Go to Step 15 |
15 | Replace the brake switch. Refer to Stop Lamp Switch Replacement Is the action complete? | -- | System OK | -- |
16 | Replace the TCM. Refer to Transmission Control Module Replacement . Is the action complete? | -- | Go to Step 15 | -- |
17 |
Has the last test failed or is the current DTC displayed? | -- | Go to Step 2 | System OK |
