Removal Procedure
Caution: Refer to Battery Disconnect Caution in the Preface section.
- Disconnect the negative battery cable.
- Disconnect the transmission control module (TCM) electrical connector.
- Remove the TCM retaining bolts.
- Remove the TCM.
Installation Procedure
Important: After replacing the TCM, refer to
Service Programming System (SPS)
to ensure the module has the latest calibrations.
- Connect the negative battery cable.
Notice: Refer to Fastener Notice in the Preface section.
- Install the TCM and retaining bolts.
Tighten
Tighten the TCM retaining bolts to 5 N·m (44 lb in).
- Connect the TCM electrical connector.
- Connect the negative battery cable.