Removal Procedure
- Remove the right rear upper quarter trim panel. Refer to
Quarter Upper Trim Panel Replacement.
- Lower the rear of the headliner for access to the antenna/cable attachment. Refer to
Headlining Trim Panel Replacement.
- Adjust the antenna cable mastic patch/tape at the roof.
- Disconnect the antenna cable from the antenna base cable connector.
- Remove the antenna cable retainer (3) from the rear header (2).
- Remove the antenna cable from the dome lamp harness clips.
- Remove the antenna cable from between the dome lamp harness and the upper quarter panel.
- Attach a piece of wire or string to the end of the antenna cable.
- Route the antenna cable through the rear shelf and along the rear wheel house.
- Adjust the right rear compartment trim panel.
- Disconnect the antenna cable from the digital radio receiver.
- Remove the antenna cable retainers from the receiver bracket.
- Remove the wire or string from the antenna cable.
- Remove the antenna cable.
Installation Procedure
- Install the antenna cable retainers to the receiver bracket.
- Connect the antenna cable to the digital radio receiver.
- Attach the wire or string used in the removal procedure to the cable being installed.
- Carefully pull the antenna cable through the rear shelf into the passenger compartment.
- Install the right rear compartment trim panel.
- Remove the wire or string from the antenna cable.
- Route the antenna cable between the dome lamp harness and the upper quarter panel.
- Install the antenna cable to the dome lamp harness clips.
- Install the antenna cable retainer (3) to the rear header (2).
- Connect the antenna cable to the antenna base cable connector.
- Install the antenna cable mastic patch/tape at the roof.
- Install the rear of the headliner. Refer to
Headlining Trim Panel Replacement.
- Install the right rear upper quarter trim panel. Refer to
Quarter Upper Trim Panel Replacement.