Callout
| Component Name
|
|
Caution: Refer to Brake Fluid Irritant Caution in the Preface section.
Notice: Refer to Brake Fluid Effects on Paint and Electrical Components Notice in the Preface section.
Notice: Always connect or disconnect the wiring harness connector from the EBCM/EBTCM
with the ignition switch in the OFF position. Failure to observe this precaution
could result in damage to the EBCM/EBTCM.
Preliminary Procedures
- Turn the ignition switch to the OFF position.
- If equipped with the 3.5L engine, remove the air cleaner assembly. Refer to
Air Cleaner Assembly Replacement
.
- If equipped with the 3.9L engine, remove the air cleaner assembly. Refer to
Air Cleaner Assembly Replacement
.
- If equipped with the 5.3L engine, remove the air cleaner assembly. Refer to
Air Cleaner Assembly Replacement
.
- Clean the electronic brake control module (EBCM) to brake pressure modulator valve (BPMV) area of any accumulated dirt and foreign material.
|
1
| Connector, EBCM Electrical
|
2
| Fitting, Brake Pipe (Qty: 6)
Notice: Refer to Fastener Notice in the Preface section.
Tighten
24 N·m (18 lb ft)
Tip
Cap the brake pipe fittings to prevent brake fluid loss and contamination. |
3
| Bolt, EBCM Mounting
Tighten
10 N·m (89 lb in) |
4
| EBCM/BPMV
|
5
| Screw, EBCM Mounting (Qty: 4)
Tighten
5 N·m (44 lb in) |
6
| EBCM
Refer to
Control Module References
for programming and setup information.
Tip
| • | Clean the sealing surfaces of the BPMV with denatured alcohol and a clean shop cloth. |
| • | Separate the EBCM from the BPMV by carefully pulling apart. Do not pry apart. |
|
