Battery Replacement RPOs LZE/LZ4/LZ9

Important: Do not tip the battery more than 40 degrees during removal.

1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
2. Remove the right front diagonal brace. Refer to Front Fender Upper Diagonal Brace Replacement .
3. Open the positive battery cable terminal cover (7).
4. Loosen the positive battery cable terminal nut.
5. Remove the positive battery cable terminal from the battery.



6. Remove the battery insulator.



7. Remove the battery hold down bolt and hold down.
8. Remove the battery.

Important: Do not tip the battery more than 40 degrees during installation.

1. Install the battery.

Notice: Refer to Fastener Notice in the Preface section.

2. Install the battery hold down and bolt.

Tighten
Tighten the bolt to 18 N·m (13 lb ft).




3. Install the battery insulator.



4. Install the positive battery cable terminal to the battery.
5. Tighten the positive battery cable terminal nut.

Tighten
Tighten the nut to 15 N·m (11 lb ft).

6. Snap closed the positive battery cable terminal cover (7).
7. Install the right front diagonal brace. Refer to Front Fender Upper Diagonal Brace Replacement .
8. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .

Battery Replacement RPO LS4

1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
2. Remove the right front diagonal brace. Refer to Front Fender Upper Diagonal Brace Replacement .
3. Reposition the positive battery cable terminal cover (1).
4. Loosen the positive battery cable terminal nut.
5. Remove the positive battery cable terminal from the battery.
6. Reposition the underhood accessory wiring junction block. Refer to Accessory Wiring Junction Block Replacement .



7. Remove the battery retainer bolts (1) and retainer (2).
8. With the aid of an assistant, remove the battery.

1. With the aid of an assistant, install the battery.
2. Install the underhood accessory wiring junction block. Refer to Accessory Wiring Junction Block Replacement .

Notice: Refer to Fastener Notice in the Preface section.

3. Install the battery retainer (2) and bolts (1).

Tighten
Tighten the bolts to 18 N·m (13 lb ft).




4. Install the positive battery cable terminal to the battery.
5. Tighten the positive battery cable terminal nut.

Tighten
Tighten the nut to 15 N·m (11 lb ft).

6. Position the positive battery cable terminal cover (2).
7. Install the right front diagonal brace. Refer to Front Fender Upper Diagonal Brace Replacement .
8. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .