For 1990-2009 cars only
Removal Procedure
- If the seat is equipped with a driver side air bag, disable the SIR system. Refer to Disabling the SIR System in SIR.
- Remove the front seat bolts.
- Remove the head restraint. Refer to Front Seat Head Restraint Replacement .
- Tip the seat forward and disconnect the electrical connector from the seat electrical harness.
- Disengage the seat hook attachments from the floor pan.
- Tip the seat forward to expose the vertical drive cables (3 or 4).
- To remove either cable perform the following procedure:
| 7.1. | Bend the flexible cable at the center. |
| 7.2. | Pull the cable out of the motor (1 or 2) and the drive screw. |
Installation Procedure
- Insert the end of the replacement cable (3 or 4) into the drive screw.
- Bend the cable and insert the other end into the motor (1 or 2).
- If required, repeat the above procedure for the second drive cable.
- Connect the electrical connector to the seat wire harness and test the seat for proper operation.
- Tip the seat forward and engage the seat hook attachments to the floor pan.
- Install the bolts that secure the adjuster to the floor pan.
- Install the head restraint. Refer to Front Seat Head Restraint Replacement .
- Enable the SIR system. Refer to Enabling the SIR System in SIR.
Important: Examine all 4 drive cables to ensure that the cables are straight.
Notice: Refer to Fastener Notice in the Preface section.
Tighten
Tighten the bolts to 42 N·m (31 lb ft).
