AUTOMATIC TRANSMISSION 700-R4 SERVICE MANUAL PAGES OMITTED
SERVICE MANUAL UPDATE
The following pages, 700-R4-57 through 700-R4-64, were omitted from the automatic transmission Section of the 1988 Corvette, Caprice and Monte Carlo Service Manuals.
Use these pages to complete this Section of the above listed Service Manuals.
Measure (Figure 203) Tool Required: J-35138 Torque Converter End Play Checking Tool
o InstalI J-35138 and measure end play - 0mm - .5mm (.020") for 245mm Torque Converters - 0mm - .6mm (.024") for 298mm Torque Converters
The Torque Converter Should Not Be Replaced if:
o The fluid has an odor, discolored or no evidence of metal or clutch plate material - Drain out as much fluid as possible - Replace the oil filter and pan gasket - Fill to proper level (Refer to Section 7A) o The converter bolt hole threads are damaged - Correct with thread insert (Refer to Section 6A) Flushing the torque converter is not recommended.
1. Torque converter (1) 2. J-21366 converter holding strap 3. Remove transmission from holding fixture
General Motors bulletins are intended for use by professional technicians, not a "do-it-yourselfer". They are written to inform those technicians of conditions that may occur on some vehicles, or to provide information that could assist in the proper service of a vehicle. Properly trained technicians have the equipment, tools, safety instructions and know-how to do a job properly and safely. If a condition is described, do not assume that the bulletin applies to your vehicle, or that your vehicle will have that condition. See a General Motors dealer servicing your brand of General Motors vehicle for information on whether your vehicle may benefit from the information.