For 1990-2009 cars only
Removal Procedure
- Disable the SIR system. Refer to Disabling the SIR System in SIR.
- Remove the knee bolster. Refer to Knee Bolster Replacement .
- Disconnect the dimmer control electrical connector.
- Use a pick in order to push up the clip. Remove the clip on the bottom of the IP lamp dimmer control.
- Remove the dimmer control (9) from the left garnish trim panel (10).
Caution: This vehicle is equipped with a Supplemental Inflatable Restraint (SIR) System. Failure to follow the correct procedure could cause the following conditions:
• Air bag deployment • Personal injury
In order to avoid the above conditions, observe the following guidelines:
• Unnecessary SIR system repairs • Refer to SIR Component Views in order to determine if you are performing service on or near the SIR components or the SIR wiring. • If you are performing service on or near the SIR components or the SIR wiring, disable the SIR system. Refer to Disabling the SIR System.
Installation Procedure
- Connect the dimmer control electrical connector.
- Install the IP lamp dimmer control (9) to the left garnish trim panel (10). Push in the dimmer control until the clip completely engages.
- Install the knee bolster. Refer to Knee Bolster Replacement .
- Enable the SIR system. Refer to Enabling the SIR System in SIR.
