Was the HVAC System Check performed?

Go to Step 2

Go to HVAC System Check

1. Turn the ignition switch to the ON position.
2. Move the blower speed selector switch to the LOW position.
3. Backprobe the connector of the blower motor resistor with a test lamp from terminal 4 to ground.

Does the test lamp light?

Go to Step 3

Go to Step 6

Test for an open in the PNK wire between the blower motor resistor and S232.

Is an open present?

Go to Step 4

Go to Step 5

Repair the open in the PNK wire between the blower motor resistor and S232. Refer to Wiring Repairs in Wiring Systems.

Is the repair complete?

Go to HVAC System Check

--

Replace the blower motor resistor. Refer to Blower Motor Resistor Replacement .

Is the repair complete?

Go to HVAC System Check

--

Replace the blower speed selector switch. Refer to Control Assembly Replacement .

Is the repair complete?

Go to HVAC System Check

--