Removal Procedure
- Discharge and recover the refrigerant. Refer to Refrigerant Recovery and Recharging .
- Remove the bolt and the inlet fitting from the top of the receiver-dryer (5).
- Remove the bolt and the outlet fitting from the top of the receiver-dryer (5).
- Remove the screw that retains the receiver-dryer in the bracket.
- Remove the receiver-dryer from the bracket.
Installation Procedure
- Lubricate new O-rings with mineral base 525 viscosity refrigerant oil.
- Install the O-rings to the inlet fittings and to the outlet fittings of the receiver-dryer.
- Install the receiver-dryer to the condenser bracket. Secure the receiver-dryer with the screw.
- Install the inlet fitting to the top of the receiver-dryer (5). Secure the receiver-dryer inlet fitting with the bolt.
- Install the outlet fitting to the top of the receiver-dryer (5). Secure receiver-dryer outlet fitting with the bolt.
- Evacuate and recharge the air conditioning (A/C) system. Refer to Refrigerant Recovery and Recharging .
- Operate the A/C system, and test the system for refrigerant leaks. Refer to Leak Testing .
Important: If you are installing a new receiver-dryer, add 10 ml (0.3 fl oz) of refrigerant oil to the A/C system.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the bolts to 9.8 N·m (86.74 lb in).
