This procedure covers the removal of the front and rear door strikers.

1. Remove the quarter lower trim panel. Refer to Quarter Lower Rear Trim Panel Replacement .
2. Mark the position of the striker with a grease pencil.
3. Remove the screws from the front door lock striker.
4. Remove the striker and the shims.
5. Remove the anchor plate.

1. Install the anchor plate.
2. Install the door lock shims and striker.
3. Install the screws to the striker.
4. Align the door lock striker to the alignment marks.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

5. Tighten the door lock striker screws.

Tighten
Tighten the striker screws to 25 N·m (18 lb ft).

6. Adjust door lock striker if required. Refer to Door Lock Striker Adjustment .
7. Install the quarter lower trim panel. Refer to Quarter Lower Rear Trim Panel Replacement.