Removal Procedure
- Cycle the sunroof window to the vent position.
- Slide the sunshade to the full rearward position.
- From inside the vehicle, remove the sunroof window screws on both sides.
Note: Do NOT scratch the roof surface or the sunroof window.
- Lift the sunroof window from the sunroof opening.
Installation Procedure
Note: Ensure that the window trade mark is at the rear of the opening.
- Position the sunroof window into the opening.
Caution: Refer to Fastener Caution in the Preface section.
- Install the sunroof window screws. Do not tighten the screws.
Tighten the bolts to
4 N·m (35 lb in).
- Carefully close the sunroof window from the vent position to the full closed position.
- Adjust the sunroof window. Refer to
Sunroof Window Height and Opening Fit Adjustment.
- Close the sunshade.
- Cycle the sunroof window to ensure proper operation and fit.