Preliminary Procedures

1. Remove the appropriate headlamp. Refer to Headlamp Replacement.
2. Remove the rocker panel molding. Refer to Rocker Panel Molding Replacement.
3. Remove the front side turn signal lamp assembly. Refer to Front Side Turn Signal Lamp Replacement.
4. Remove the front fender insulator. Refer to Front Fender Insulator Replacement.
5. Remove the front bumper fascia outer bracket. Refer to Front Bumper Fascia Outer Bracket Replacement.
6. Remove the front bumper fascia bracket. Refer to Front Bumper Fascia Bracket Replacement

1

Front Fender Bolt (Qty: 8)

Caution: Refer to Fastener Caution in the Preface section.

Procedure

Use a grease pencil to mark the alignment of the fender before removing the bolts.

Tighten
9 N·m (80 lb in)

2

Front Fender Nut

Tighten
9 N·m (80 lb in)

3

Front Fender/Fascia Retainer

Procedure

Pull gently on the front fascia panel to remove the fascia from the fender.

4

Front Fender

Procedure

1. Disconnect any electrical connectors.
2. Transfer parts as needed.
3. Align the fender after installing as needed.