Note: Clean the fuel and evaporative emission (EVAP) connections and surrounding areas prior to disconnecting the lines in order the avoid possible system contamination.

1. Remove the fuel fill cap.
2. Drain the fuel tank. Refer to Fuel Tank Draining.
3. Remove the right rear wheelhouse liner. Refer to Rear Wheelhouse Panel Liner Replacement.
4. Remove the fuel tank fill pipe screws (1) from the fuel tank fill pipe housing.
5. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
6. Remove the fuel tank fill pipe bolt (2) from the underbody side rail.



7. Loosen the fuel fill pipe hose clamp (3) at the fuel tank.
8. Separate the fuel fill pipe hose from the fuel tank.
9. Disconnect the fuel tank fill EVAP pipe quick connect fitting (2) from the fuel tank vent pipe (1). Refer to Plastic Collar Quick Connect Fitting Service.
10. Remove the fuel tank fill pipe.

1. Install the fuel tank fill pipe.
2. Install the fuel fill pipe hose to the fuel tank.
3. Connect the fuel tank fill EVAP pipe quick connect fitting (2) to the fuel tank vent pipe (1). Refer to Plastic Collar Quick Connect Fitting Service.

Caution: Refer to Fastener Caution in the Preface section.

4. Tighten the fuel fill pipe hose clamp (3) at the fuel tank and tighten the clamp to 4 N·m (35 lb in).



5. Install the fuel tank fill pipe bolt (2) to the underbody side rail and tighten to 9 N·m (80 lb in).
6. Install the right rear wheelhouse liner. Refer to Rear Wheelhouse Panel Liner Replacement.
7. Lower the vehicle.
8. Install the fuel tank fill pipe screws (1) to the fuel tank fill pipe housing and tighten the screws to 1.5 N·m (13 lb in).
9. Refill the fuel tank.
10. Tighten the fuel fill cap.
11. Inspect for leaks:

11.1.

Turn ON the ignition, with the engine OFF for 10 seconds.

11.2.

Turn OFF the ignition for 10 seconds.

11.3.

Turn ON the ignition, with the engine OFF.

11.4.

Inspect for fuel leaks.