Sunroof Sunshade Replacement CF5

Note: Use caution NOT to loosen the center fastener for the water gutter. If the fastener unhooks, it will be necessary to remove the dome lamp to gain access to the water gutter hole to reinstall the retainer. If equipped.

1. Remove the sunroof window panel from the sunroof module. Refer to Sunroof Window Replacement.



2. Remove the sunroof sunshade (7) from the module.
3. Do the following from the right side and through the sunroof opening, outside the vehicle:

3.1.	Close the sunshade to with in an inch of the front opening.

3.2.	Carefully arch the rear center of the sunshade.

3.3.	Pull upward in the rear center of the sunshade (7).

3.4.	Release the tabs (5, 6) from under the water gutter.

3.5.	Lift upward in the rear center of the sunshade until the guide tabs (3) release from the track.

3.6.	Slightly rotate the sunshade clockwise at the same time push forward releasing (4, 2) and then (1).




4. Remove the sunshade from the tracks.

1. Install the sunshade front tab to the left corner of sunroof track.



2. Do the following from outside the vehicle and through the opening of the sunroof window from the right of left sides.

2.1.	Install the guide tab (1) into left front corner.

2.2.	Rotor the sunshade until the guide tab (2) is insert into the right corner.

2.3.	Insert the sunshade guide tab (3) flex the sunshade panel as needed to seat.

2.4.	Arch the sunshade in the rear right corner (4) until guide tab can be installed.

2.5.	Carefully flex the rear of the sunshade under water drain channel to allow the sunshade guide tabs (5)  and  (6) to clear.

3. While seated inside the vehicle with the sunshade in the closed position, verify that the front of the sunroof is not bent upward. If the sunshade is bent, grab the front middle of the sunshade and carefully pull down to adjust the shade to fit the front center edge.
4. Install the sunroof window panel. Refer to Sunroof Window Replacement.