For 1990-2009 cars only
Removal Procedure
- Apply a double layer of masking tape to the roof panel along the rear edge of the sunroof opening.
- Cycle the sunroof window to the vent position, then to 25 mm (1 in) rearward.
- Remove the sunroof module assembly. Refer Sunroof Module Assembly Replacement .
- From the underside of the sunroof window track assembly, remove the 3 screws that secure the water gutter to the forward cross-member of the track assembly.
- Pull downward on the front edge of the sunroof water gutter to allow standing bosses to clear the cross-member. Slide the sunroof water gutter rearward to release the retaining tabs from the slots on the track assembly.
- Remove the sunroof water gutter from the track assembly.
Installation Procedure
- Position the sunroof water gutter to the sunroof window track assembly.
- Pull downward on the front edge of the sunroof water gutter to allow standing bosses to clear the cross-member. Seat the tabs on the sunroof water gutter into the slots in the track assembly, and push the sunroof water gutter forward until the tabs lock into place.
- Ensure that all tabs are secured.
- Install the sunroof water gutter screws.
- Install the sunroof module assembly. Refer Sunroof Module Assembly Replacement .
- Remove the masking tape from the roof panel.
Notice: Refer to Fastener Notice in the Preface section.
Tighten
Tighten the screws to 2 N·m (18 lb in).
