Front Side Door Molding Replacement. Chevrolet Malibu 2008

For 1990-2009 cars only

Makes 🢒 Chevrolet 🢒 2008 🢒 Malibu 🢒 Body Hardware and Trim 🢒 Exterior Trim 🢒 Front Side Door Molding Replacement

Callout	Component Name
Preliminary Procedure Ensure the molding temperature is a minimum of 16°C or 60°F prior to installing the bodyside molding to the door.
1	Front Side Door Molding Assembly Procedure When removing protective liners from adhesive tape, be careful not to touch tape with hands and do not allow tape to come in contact with dirt or any foreign matter prior to adhesion. Use a J 25070 Heat Gun or equivalent to remove the bodyside molding. Clean all adhesive from the door side, wipe surface dry with a clean lint-free towel prior to installing new side door moldings. Align the molding integral pin to the rear round hole in door bodyside, peel adhesive tape protective liner from molding and secure the bodyside center molding to the door. Using a dry clean towel, wet out the molding working from the rear door edge to the front. Ensure full adhesion is made to the door. Special Tools J 25070 Heat Gun - 500-750F

Callout

Component Name

Ensure the molding temperature is a minimum of 16°C or 60°F prior to installing the bodyside molding to the door.

Front Side Door Molding Assembly

When removing protective liners from adhesive tape, be careful not to touch tape with hands and do not allow tape to come in contact with dirt or any foreign matter prior to adhesion.
Use a J 25070 Heat Gun or equivalent to remove the bodyside molding. Clean all adhesive from the door side, wipe surface dry with a clean lint-free towel prior to installing new side door moldings.
Align the molding integral pin to the rear round hole in door bodyside, peel adhesive tape protective liner from molding and secure the bodyside center molding to the door.
Using a dry clean towel, wet out the molding working from the rear door edge to the front.
Ensure full adhesion is made to the door.

J 25070 Heat Gun - 500-750F