GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2007 🢒 Malibu 🢒 Body Repair 🢒 Collision Repair 🢒 Rear Window Panel Replacement

Removal Procedure

    Caution: Refer to Approved Equipment for Collision Repair Caution in the Preface section.

  1. Disable the SIR system. Refer to SIR Disabling and Enabling .
  2. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
  3. Remove all related panels and components.
  4. Repair as much of the damaged area as possible. Refer to Dimensions - Body .
  5. Remove the sealers and anti-corrosion materials from the repair area, as necessary. Refer to Anti-Corrosion Treatment and Repair .

    6. Object Number: 1220147 Size: SH

    Important: Note the number and location of the factory welds for installation of the rear window panel.

  6. Locate and drill out all the necessary factory welds.

    7. Object Number: 1220150 Size: SH
  7. Remove the rear window panel.

Installation Procedure

    Object Number: 1220152 Size: SH

    Important: If the location of the original plug weld holes can not be determined, space the plug weld holes every 40 mm (1½ in) apart.

  1. Drill 8 mm (5/16 in) plug weld holes in the service part as necessary in the corresponding locations noted on the original panel.
  2. Prepare all mating surfaces for welding as necessary.
  3. Apply 3M Weld-Thru Coating P/N 05916 or equivalent to all mating surfaces.

    4. Object Number: 1220150 Size: SH
  4. Position the rear window panel.

    5. Object Number: 1220147 Size: SH
  5. Plug weld accordingly.
  6. Clean and prepare all of the welded surfaces.
  7. Install all of the related panels and components.
  8. Apply the sealers and anti-corrosion materials to the repair area, as necessary. Refer to Anti-Corrosion Treatment and Repair .
  9. Paint the repaired area. Refer to Basecoat/Clearcoat Paint Systems .
  10. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
  11. Enable the SIR system. Refer to SIR Disabling and Enabling .