Cooling Fan and Shroud Replacement L61

1. Remove the left and right headlamp. Refer to Headlamp Assembly or Headlamp Bulb and/or Cornering, Sidemarker, Park, Turn Signal Bulb Replacement .
2. Unclip the upper transmission oil cooler pipe from the fan shroud. Do not disconnect transmission oil cooler pipe from transmission or radiator.



3. Loop a rope around each of the upper 2 tabs on the condenser and tie a rope around the upper tie bar.
4. Remove the upper radiator support bracket bolts.



5. Remove the upper radiator support brackets.



6. Pry upward on the fan shroud tabs at the radiator clips.



7. Raise the vehicle. Refer to Lifting and Jacking the Vehicle .
8. Remove the lower radiator air deflector retainers.
9. Remove the lower radiator air deflector.



10. Remove the right front fender liner. Refer to Front Fender Liner Replacement .
11. Remove the right radiator air deflector retainers.
12. Remove the right radiator air deflector.



13. Remove the left radiator air deflector retainers.
14. Remove the left radiator air deflector.



15. Remove the lower radiator support bracket bolts.
16. Remove the lower radiator support brackets.
17. Remove the fan wire harness connectors.



18. Remove the fan shroud assembly.

1. Install the fan shroud assembly.



2. Bend the radiator air side seals and insert the seals into the channel of the intake air splash shields.



3. The radiator air side seals must be in the proper position for proper air flow.



4. Install the lower radiator support brackets.

Notice: Refer to Fastener Notice in the Preface section.

5. Install the lower radiator support bracket bolts.

Tighten
Tighten the bolts to 60 N·m (44 lb ft).

6. Install the fan wire harness connectors.




Important: Radiator air deflectors must be properly installed or reduced A/C and engine cooling system performance could occur.

7. Install the left radiator air deflector.
8. Install the left radiator air deflector retainers.



9. Install the right radiator air deflector.
10. Install the right radiator air deflector retainers.
11. Install the right front fender liner. Refer to Front Fender Liner Replacement .



12. Install the lower radiator air deflector.
13. Install the lower radiator air deflector retainers.
14. Lower the vehicle.



15. Snap the fan shroud tabs into the radiator clips.
16. Remove the rope attached to the condenser and upper tie bar.



17. Install the upper radiator support brackets.

Important: Do not allow the upper bracket to twist when tightening the screw or vibration may result.




18. Install the upper radiator support bracket bolts.

Tighten
Tighten the bolts to 10 N·m (7 lb ft).

19. Clip the upper transmission oil cooler pipe to the shroud.
20. Install the right and left headlamp. Refer to Headlamp Assembly or Headlamp Bulb and/or Cornering, Sidemarker, Park, Turn Signal Bulb Replacement .

Cooling Fan and Shroud Replacement LZ4, LZ9

Tools Required

J 38185 Hose Clamp Pliers

1. Drain the coolant. Refer to Cooling System Draining and Filling .
2. Remove the left and right headlamp. Refer to Headlamp Assembly or Headlamp Bulb and/or Cornering, Sidemarker, Park, Turn Signal Bulb Replacement .
3. Remove the upper transmission oil cooler pipe from the radiator. Refer to Transmission Fluid Cooler Hose/Pipe Quick-Connect Fitting Disconnection and Connection .



4. Loop a rope around each of the upper 2 tabs of the condenser and tie a rope around the upper tie bar.
5. Remove the upper radiator support bracket bolts.



6. Remove the upper radiator support brackets.



7. Pry upward on the fan shroud tabs at the radiator clips.



8. Raise the vehicle. Refer to Lifting and Jacking the Vehicle .
9. Remove the lower radiator air deflector retainers.
10. Remove the lower radiator air deflector.



11. Remove the right front fender liner. Refer to Front Fender Liner Replacement .
12. Remove the right radiator air deflector retainers.
13. Remove the right radiator air deflector.



14. Remove the left radiator air deflector retainers.
15. Remove the left radiator air deflector.
16. Reposition the radiator outlet hose clamp at the radiator using the J 38185 .
17. Remove the radiator outlet hose from the radiator.
18. Remove the fan wire harness connectors.



19. Remove the lower radiator support bracket bolts.
20. Remove the lower radiator support brackets.
21. Place a drain pan under the transmission oil cooler pipes.
22. Remove the transmission oil cooler pipes attachment nut from the transmission.



23. Remove both transmission oil cooler pipes from the transmission.



24. Remove the transmission oil cooler pipe clip from the fan shroud.
25. Remove the lower transmission oil cooler pipe from the radiator. Refer to Transmission Fluid Cooler Hose/Pipe Quick-Connect Fitting Disconnection and Connection .
26. Remove the transmission oil cooler pipes.
27. Remove the fan wire harness connectors.



28. Remove the fan shroud assembly.

1. Install the fan shroud assembly.



2. Install the transmission oil cooler pipes.
3. Install the lower transmission oil cooler pipe to the radiator. Refer to Transmission Fluid Cooler Hose/Pipe Quick-Connect Fitting Disconnection and Connection .



4. Install the transmission oil cooler pipe clip to the fan shroud.



5. Install both transmission oil cooler pipes to the transmission.

Notice: Refer to Fastener Notice in the Preface section.

6. Install the transmission oil cooler pipe attachment nut to the transmission.

Tighten
Tighten the nut to 7 N·m (62 lb in).




7. Bend the radiator air side seals and insert the seals into the channel of the intake air splash shields.



8. The radiator air side seals must be in the proper position for proper air flow.



9. Install the lower radiator support brackets.
10. Install the lower radiator support bracket bolts.

Tighten
Tighten the bolts to 60 N·m (44 lb ft).

11. Install the fan wire harness connectors.
12. Install the radiator outlet hose to the radiator.
13. Reposition the radiator outlet hose clamp at the radiator using the J 38185 .




Important: Radiator air deflectors must be properly installed or reduced A/C and engine cooling system performance could occur.

14. Install the left radiator air deflector.
15. Install the left radiator air deflector retainers.



16. Install the right radiator air deflector.
17. Install the right radiator air deflector retainers.
18. Install the right front fender liner. Refer to Front Fender Liner Replacement .



19. Install the lower radiator air deflector.
20. Install the lower radiator air deflector retainers.
21. Lower the vehicle.



22. Snap fan shroud tabs into the radiator clips.
23. Remove the rope attached to the condenser and upper tie bar.



24. Install the upper radiator support brackets.

Important: Do not allow the upper bracket to twist when tightening the screw or vibration may result.




25. Install the upper radiator support bracket bolts.

Tighten
Tighten the bolts to 10 N·m (89 lb in).

26. Install the upper transmission oil cooler pipe to the radiator. Refer to Transmission Fluid Cooler Hose/Pipe Quick-Connect Fitting Disconnection and Connection .
27. Install the right and left headlamp. Refer to Headlamp Assembly or Headlamp Bulb and/or Cornering, Sidemarker, Park, Turn Signal Bulb Replacement .
28. Fill the coolant. Refer to Cooling System Draining and Filling .
29. Inspect the transmission fluid level. Refer to Transmission Fluid Check .