Important: The new wiper drive system module does not include the wiper motor nor the motor support bracket. You must install the old components to the new wiper system module.

1. Remove the wiper arms. Refer to Windshield Wiper Arm Replacement .
2. Remove the air inlet grille panel. Refer to Air Inlet Grille Panel Replacement in Body Front End.



3. Remove the fasteners attaching the wiper module to the plenum.
4. Carefully lift the wiper module out of the plenum.



5. Disconnect the electrical connector from the wiper motor.
6. Disconnect the clip retaining the electrical harness to the wiper module.
7. Remove the wiper module assembly from the vehicle.



8. Remove the wiper motor. Refer to Windshield Wiper Motor Replacement .

1. Install the wiper motor. Refer to Windshield Wiper Motor Replacement .



2. Connect the electrical connector to the wiper motor.
3. Connect the clip retaining the electrical harness to the wiper module.



4. Position the wiper module assembly into the plenum.

Notice: Refer to Fastener Notice in the Preface section.

5. Install the fasteners attaching the wiper module assembly to the plenum.

Tighten
Tighten the fasteners to 10 N·m (89 lb in).

6. Install the air inlet grille panel. Refer to Air Inlet Grille Panel Replacement in Body Front End.
7. Install the wiper arms. Refer to Windshield Wiper Arm Replacement .
8. Inspect the washers for proper operation.