For 1990-2009 cars only
Removal Procedure
- Remove the front seat. Refer to Front Seat Replacement - Bucket .
- Remove the recliner handle. Refer to Driver Seat and Passenger Seat Recliner Handle Replacement .
- Remove the inner and outer trim covers. Refer to Front Seat Cushion Outer Trim Panel Replacement .
- Remove the J-strips from the seat frame.
- Remove the J-strip on the recliner rod.
- If the vehicle is equipped with a heated seat, disconnect the heated seat wiring connector.
- Remove the seat cushion cover and pad from the seat frame.
- Remove the hog rings from the under side of the seat cushion.
- Pull the cushion cover (1) off of the pad (2).
Installation Procedure
- Push the cushion cover (1) over the cushion pad (2).
- Install the hog rings on the under side of the seat cushion.
- Install the seat cushion cover and pad onto the seat frame.
- If the vehicle is equipped with a heated seat, connect the heated seat wiring connector.
- Install the J-strips to the seat frame. Start at the front end and work toward the rear.
- Install the J-strip to the recliner rod.
- Install the recliner handle. Refer to Driver Seat and Passenger Seat Recliner Handle Replacement .
- Install the inner and outer trim covers. Refer to Front Seat Cushion Outer Trim Panel Replacement .
- Install the front seat. Refer to Front Seat Replacement - Bucket .
Important: Verify that the listing wire is aligned with the trim cover.
