GM Service Manual Online
For 1990-2009 cars only

Circuit Description

The body control module (BCM) supplies battery positive voltage to the courtesy lamps, underhood lamp, I/P compartment lamp, console lamp and both visor vanity mirror lamps. In the event that any of these lamps were to remain illuminated for more than 20 minutes with the ignition switch in the OFF position, the BCM will deactivate the inadvertent power courtesy lamps supply voltage circuit to prevent a total battery discharge condition.

Conditions for Running the DTC

The battery voltage must be between 9-16 volts.

Conditions for Setting the DTC

DTC B1480 00 The inadvertent power courtesy lamps supply voltage circuit to the courtesy lamps, underhood lamp, I/P compartment lamp, console lamp and both visor vanity mirror lamps is shorted to ground for longer than 1 second.

Action Taken When the DTC Sets

The courtesy lamps, underhood lamp, I/P compartment lamp, console lamp and both visor vanity mirror lamps will not operate.

Conditions for Clearing the DTC

    • This DTC will clear on current status after the condition for setting the fault is corrected.
    • A history DTC will clear after 100 consecutive ignition cycles without a fault present.
    • History and current DTCs can be cleared using a scan tool.

Diagnostic Aids

Perform a visual inspection for loose or poor connections at all related components. Refer to Testing for Intermittent Conditions and Poor Connections in Wiring Systems.

Step

Action

Yes

No

Schematic Reference: Interior Lights Schematics

Connector End View Reference: Master Electrical Component List in Wiring Systems

1

Did you perform the Diagnostic System Check - Vehicle?

Go to Step 2

Go to Diagnostic System Check - Vehicle in Vehicle DTC Information

2

  1. Install a scan tool.
  2. Turn on the ignition.

Is DTC B1480 present?

Go to Step 3

Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems

3

Test the inadvertent power courtesy lamps supply voltage circuit for a short to ground. Refer to Circuit Testing and Wiring Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 5

Go to Step 4

4

Important: After replacing the body control module (BCM), perform the setup procedure. Refer to Body Control Module (BCM) Programming/RPO Configuration in Computer/Integrating Systems.

Replace the BCM. Refer to Body Control Module Replacement in Computer/Intergrating Systems.

Did you complete the replacement?

Go to Step 5

--

5

  1. Use the scan tool in order to clear the DTCs.
  2. Operate the vehicle within the Conditions for Running the DTC as specified in the supporting text.

Does the DTC reset?

Go to Step 2

System OK