Circuit Description
The body control module (BCM) monitors the cruise control set/coast and resume/accelerate switch signal circuit. When a cruise control function switch is activated, the BCM detects a predetermined voltage signal. The BCM sends a GMLAN serial data message to the powertrain control module (PCM) indicating the function that has been requested.
Conditions for Running the DTC
| • | The ignition is ON. |
| • | The cruise control On/Off switch is ON. |
| • | The set/coast switch or the resume/accel switch are individually pressed. |
Conditions for Setting the DTC
The PCM receives an invalid cruise control switch status GMLAN serial data message from the BCM.
Action Taken When the DTC Sets
| • | The cruise control system is disabled. |
| • | The PCM stores the DTC information into memory when the diagnostic runs and fails. |
| • | The malfunction indicator lamp (MIL) will not illuminate. |
| • | The PCM records the operating conditions at the time the diagnostic fails. The PCM stores this information in the Failure Records. |
Conditions for Clearing the MIL/DTC
| • | A last test failed, or the current DTC, clears when the diagnostic runs and does not fail. |
| • | A history DTC clears after 40 consecutive warm-up cycles, if failures are not reported by this or any other emission related diagnostic. |
| • | Use the scan tool in order to clear the DTC. |
Diagnostic Aids
| • | This DTC may be stored as a history DTC without affecting the operation of the module. If stored only as a history DTC and not retrieved as a current DTC, do not replace the module. |
| • | If this DTC is retrieved as both a current and history DTC, replace the module. |
Step | Action | Yes | No |
|---|---|---|---|
Schematic Reference: Cruise Control Schematics Connector End View Reference: Computer/Integrating Systems Connector End Views in Computer/Integrating Systems | |||
1 | Did you perform the Diagnostic System Check - Vehicle? | Go to Step 2 | Go to Diagnostic System Check - Vehicle in Vehicle DTC Information |
2 | Is DTC P0575 current in the powertrain control module? | Go to Step 3 | Go to Diagnostic Aids |
3 |
Important: Program the replacement body control module (BCM). The BPP sensor must be calibrated after replacement. Replace the BCM. Refer to Body Control Module Replacement . Did you complete the replacement? | Go to Step 4 | -- |
4 |
Does the DTC reset? | Go to Step 2 | System OK |
