Crankshaft Position Sensor Replacement 7X

1. Turn OFF the ignition.
2. Raise the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
3. Disconnect the crankshaft position (CKP) sensor electrical connector.
4. Remove the attaching bolt/screw.
5. Remove the sensor from the engine.
6. Inspect for wear, cracks, or leakage if the sensor is not being replaced.

1. Lubricate the O-ring with clean engine oil before installation and replace the O-ring if damaged.



2. Install the sensor to the engine block.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

3. Reinstall the sensor attaching bolt.

Tighten
Tighten the bolt to 8 N·m (71 lb in).

4. Connect the sensor electrical connector.
5. Lower the vehicle.

Crankshaft Position Sensor Replacement 24X

1. Turn OFF the ignition.
2. Remove the serpentine drive belt from the crankshaft pulley. Refer to Drive Belt Replacement in Engine Mechanical.
3. Raise the vehicle on hoist. Refer to Lifting and Jacking the Vehicle in General Information.
4. Remove the crankshaft harmonic balancer. Refer to Crankshaft Balancer Replacement in Engine Mechanical.
5. Note the routing of sensor harness before removal.
6. Remove the harness retaining clip (3) and the bolt (4).
7. Disconnect the sensor electrical connector.
8. Remove the sensor bolts (4).
9. Remove the sensor (1).

1. Install the 24X crankshaft position sensor (1) and bolts (4) and route the harness as noted during removal.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

2. Install the harness retaining clip with the bolt (3).

Tighten
Tighten the bolts to 10 N·m (8 lb ft).

3. Connect the sensor electrical connector.
4. Reinstall the balancer on the crankshaft. Refer to Crankshaft Balancer Replacement in Engine Mechanical.
5. Lower the vehicle.
6. Install the serpentine drive belt. Refer to Drive Belt Replacement in Engine Mechanical.
7. Perform the Crankshaft Position System Variation Learn .