DTC U2202. Chevrolet Lumina VE 2008

For 1990-2009 cars only

Makes 🢒 Chevrolet 🢒 2008 🢒 Lumina VE 🢒 Safety and Security 🢒 Supplemental Inflatable Restraints 🢒 DTC U2202

Diagnostic Instructions

•	Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure.

•	Review Strategy Based Diagnosis for an overview of the diagnostic approach.

•	Diagnostic Procedure Instructions provides an overview of each diagnostic category.

DTC Descriptor

DTC U2202: No Communication With Rear Control Panel

With the ignition in either the ACC position or the ON position the rear seat entertainment (RSE) interface module continuously sends a communication signal to the rear seat entertainment (RSE) control panel. Upon receiving the signal, the RSE control panel sends a reply signal, confirming that it can communicate. DTC U2202 will set to indicate the RSE control panel has not received a communication signal or replied when the RSE interface module has requested operation.

Conditions for Running the DTC

DTC U2202 runs continuously once a valid RSE control panel response occurs.

Conditions for Setting the DTC

The RSE interface module does not receive a response from the RSE control panel after 3 consecutive communication attempts.

Action Taken When the DTC Sets

The rear seat entertainment system fails to operate.

Conditions for Clearing the DTC

•	The current DTC will clear when the RSE interface module receives a communication reply from the RSE control panel.

•	The history DTC will clear after 50 fault-free ignition cycles have occurred.

Reference Information

Electrical Information Reference

•	Circuit Testing

•	Connector Repairs

•	Testing for Intermittent Conditions and Poor Connections

•	Wiring Repairs

Scan Tool Reference

Control Module References for scan tool information

Circuit/System Testing

Verify that DTC U2202 is set.
Ignition OFF, disconnect the audio/video interface module and RSE control panel harness connectors.
Test the RSE interface module and RSE control panel; communication, power and ground circuits for short to ground or an open/high resistance.

⇒	If the circuits do not test normal, repair or replace the effected circuit(s).

⇒	If the circuits test normal, replace the RSE control panel.

Using the scan tool, select the DTC display function. If DTC U2202 resets, replace the audio/video interface module.

Repair Instructions

Perform the Diagnostic Repair Verification.

•	Video Disc Player Control Replacement

•	Audio/Video Interface Module Replacement