1. Remove the air intake tube.
2. Remove the IAC valve, and TP sensor, electrical connectors.
3. Remove the (MAF) mass air flow sensor
4. Remove the accelerator control and cruise control cables.
5. Remove the accelerator control cable bracket.
6. Remove the PCV hose.
7. Remove the nuts and bolts holding the throttle body to the intake manifold.
8. Remove the throttle body assembly.

Notice: Do not use solvent of any type when cleaning the gasket surfaces on the intake manifold and the throttle body assembly, as damage to the gasket surfaces and throttle body assembly may result.

1. Clean the gasket surface on the intake manifold and the throttle body assembly.
2. Install a new gasket, if necessary.
3. Install the throttle body assembly.
4. Install the throttle body retaining nuts and bolts (3).

Tighten
Tighten the throttle body retaining nuts and bolts to 28 N·m (21  lb. ft.).

5. Install the (MAF) mass air flow.
6. Install the IAC valve, and TP sensor, electrical connectors.
7. Install the accelerator control cable bracket.
8. Install the accelerator control and cruise control cables.
9. Install the PCV hose.
10. Install the air intake tube.

Important: The throttle should operate freely without binding between full closed and wide open throttle.

11. Inspect and check for complete throttle opening and closing positions by operating the accelerator pedal. Also check for poor carpet fit under the accelerator pedal.