Tools Required

1. Remove the mount nuts from the bottom of the frame.
2. Remove the transaxle mount nuts. Refer to Transaxle Mounts in Automatic Transaxle.
3. Raise the engine to provide clearance. using J 28467-360 and J 28467-90

.




4. Remove the mount to engine mount bracket nuts.
5. Remove the engine mount.

Tools Required

1. Install the engine mount nuts to the engine mount bracket.

Tighten
Tighten the nuts to 44 N·m (32 lb ft).

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

2. Lower the engine.
3. Install the mount to frame.

Tighten
Tighten the bolt to 44 N·m (32 lb. ft).

4. Install the transaxle mount frame side bracket nuts to the frame. Refer to Automatic Transaxle.
5. Remove the J 28467-360 , and theJ 28467-90 .