The following procedure has been changed, please note your copies of the Service Manual.
Remove or Disconnect
1. Battery negative cable. 2. 2nd row seating from vehicle. 3. Seat belt retaining bolts from center pillar and body lock pillar panels. 4. Quarter upper trim finishing panel. 5. Center pillar trim finishing panel. 6. Rear wheel house trim finishing panel. 7. Body lock pillar trim finishing panel. 8. Quarter lower trim finishing panel. 9. Electrical connector at blower resistor. 10. Auxiliary blower resistor from blower duct assembly.
Install or Connect
1. Auxiliary blower resistor to blower duct assembly. 2. Electrical connector at auxiliary blower resistor. 3. Quarter lower trim finishing panel. 4. Body lock pillar trim finishing panel. 5. Rear wheelhouse trim finishing panel. 6. Center pillar trim finishing panel. 7. Quarter upper trim finishing panel. 8. Seat belt retaining bolts at center pillar and body lock pillar panels. 9. 2nd row seating into vehicle. 10. Battery negative cable.
AUXILIARY BLOWER REAR DUCT (Refer to Figure 1)
2 SCREW 3 BODY WIRING HARNESS 4 BLOWER RESISTOR HARNESS 5 AUXILIARY SLOWER ASSEMBLY 6 AUXILIARY BLOWER RESISTOR
General Motors bulletins are intended for use by professional technicians, not a "do-it-yourselfer". They are written to inform those technicians of conditions that may occur on some vehicles, or to provide information that could assist in the proper service of a vehicle. Properly trained technicians have the equipment, tools, safety instructions and know-how to do a job properly and safely. If a condition is described, do not assume that the bulletin applies to your vehicle, or that your vehicle will have that condition. See a General Motors dealer servicing your brand of General Motors vehicle for information on whether your vehicle may benefit from the information.