Removal Procedure
- Remove the front seat. Refer to Seat Replacement .
- Place the reclining seat back in the forward position.
- Remove the finish trim panel. Refer to Front Seat Trim Panel Replacement .
- Remove the recliner tilt handle screws.
- Remove the recliner lever (3) from the seat.
- Move the seat back cover in order to expose the recliner bolts.
- Remove the upper recliner bolts (1).
- Remove the lower recliner bolts (2).
- Remove the recliner mechanism from the seat.
Remove the retainers (driver's side AM6).
Installation Procedure
- Install the recliner mechanism to the seat.
- Install the lower recliner bolts (2).
- Install the upper recliner bolts (1).
- Position the seat back cover over the recliner bolts.
- Install the recliner lever (3) to the seat.
- Install the recliner tilt handle screws.
- Install the retainers (driver's side AM6).
- Install the finish panel. Refer to Front Seat Trim Panel Replacement .
- Place the reclining seat back in the forward position.
- Install the front seat. Refer to Seat Replacement .
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the lower recliner bolts to 25 N·m (18 lb ft).
Tighten
Tighten the upper recliner bolts to 25 N·m (18 lb ft).
Tighten
Tighten the recliner tilt handle screws to 3 N·m (27 lb in).
