Turn Signal and Multifunction Switch Assembly - Disassemble - Off Vehicle Column Shift

1. Remove the tilt lever.
2. Remove the hazard knob.
3. Remove the turn signal switch lever.
4. Remove the pivot and pulse dimmer switch assembly. Refer to Turn Signal Cancel Cam and Upper Bearing Inner Race - Disassemble - Off Vehicle .



5. Remove the 3 binding head cross recess screws (1) from the turn signal switch assembly (2).

Important: Use care not to damage the wires when pulling through the lock housing cover and sleeve assembly (3).

6. If removal of the turn signal switch assembly (2) is not needed let it hang freely.



7. Remove the turn signal switch assembly connector from the lock housing cover and sleeve assembly following these steps:

7.1.	Remove the turn signal switch assembly connector from the bulkhead connector.

7.2.	Attach mechanics wire to the turn signal switch assembly connector for reassembly.

7.3.	Pull the turn signal switch assembly connector through the lock housing cover and sleeve assembly.