Caution: All floor pan insulator material must meet Federal Vehicle Safety Standards for flammability. Failure to do so could result in personal injury and/or vehicle damage.
The floor pan insulators have been designed for the higher floor pan temperatures
that result from the use of the catalytic converter in the exhaust system.
When servicing a vehicle in the field any insulators that disturbed or
removed is reinstalled in the original sequence and the location.
When servicing or replacing interior insulators observe the following
instructions:
| • | Insulators must be installed
in the original position and sequence. |
| • | If it is necessary to replace an insulator, use the specified
service part. |
| • | When installing an insulator do not enlarge cutouts or holes that
are used for the attachment of interior components such as seats or safety
belts. |
| • | Route over the floor pan insulators in the original location and
clip the cross body harness in place for the following interior components: |
| - | Lamp belt warning light |
| • | Do not apply the spray-on deadeners and the trim adhesives to
the top of the floor pan at the area directly over the catalytic converter
or the muffler(s). |
