Step | Action | Value(s) | Yes | No |
|---|---|---|---|---|
1 | Was the Wiper/Washer System Check performed? | -- | Go to Step 2 | |
2 |
Does the resistance vary within the specified range? | 110 Kohms to1200 Kohms | Go to Step 4 | Go to Step 3 |
3 | Replace the wiper/washer switch. Refer to Multifunction Turn Signal Lever Replacement - On Vehicle in Steering Wheel and Column -Tilt. Is the repair complete? | -- | -- | |
4 | Measure the resistance between wiper/washer switch connector C201, terminals E9 and E13, using a J39200. Is the resistance less than the specified value? | 3 ohms | Go to Step 6 | Go to Step 5 |
5 | Replace the wiper/washer switch. Refer to Multifunction Turn Signal Lever Replacement - On Vehicle in Steering Wheel and Column -Tilt. Is the repair complete? | -- | -- | |
6 | Inspect for a poor connection or an open circuit in CKT 91 or CKT 94. Is a poor connection or an open present? | -- | Go to Step 7 | Go to Step 8 |
7 | Repair the poor connection or the open in CKT 91 or CKT 94. Is the repair complete? | -- | -- | |
8 | Replace the wiper motor cover. Refer to Wiper Motor Cover Replacement . Is the repair complete? | -- | -- |
