For 1990-2009 cars only
Removal Procedure
- Disable the SIR system. Refer to SIR Disabling and Enabling.
- Disconnect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection.
- Remove the steering wheel. Refer to Steering Wheel Replacement .
- Remove the steering column filler. Refer to Steering Column Opening Filler Replacement.
- Remove the tilt lever.
- Remove the 2 retaining screws from the lower steering column trim cover.
- Separate the upper steering column cover from the lower steering column cover and remove them from the steering column.
Caution: Refer to SIR Caution in the Preface section.
Caution: Unless directed otherwise, the ignition and start switch must be in the OFF or LOCK position, and all electrical loads must be OFF before servicing any electrical component. Disconnect the negative battery cable to prevent an electrical spark should a tool or equipment come in contact with an exposed electrical terminal. Failure to follow these precautions may result in personal injury and/or damage to the vehicle or its components.
Installation Procedure
- Position the upper steering column cover and the lower steering column cover together on the steering column.
- Install the 2 retaining screws to the lower steering column trim cover.
- Install the tilt lever.
- Install the steering column filler. Refer to Steering Column Opening Filler Replacement.
- Install the steering wheel. Refer to Steering Wheel Replacement.
- Connect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection.
- Enable the SIR system. Refer to SIR Disabling and Enabling.
Important: Make sure that the tabs from the upper steering column cover line up to the lower steering column cover and engage properly.
Notice: Refer to Fastener Notice in the Preface section.
Tighten
Tighten the screws to 3 N·m (27 lb in).
