Removal Procedure
- Remove the front or rear door lock pillar trim to gain access to the anchor plate.
- Mark the position of the striker with a grease pencil.
- Remove the screws from the front door lock striker.
- Remove the striker and the shims.
- Remove the anchor plate.
Installation Procedure
- Install the anchor plate.
- Install the door lock shims and striker.
- Install the striker screws.
- Align the door lock striker to the alignment marks.
Notice: Use the correct fastener in the correct location. Replacement fasteners
must be the correct part number for that application. Fasteners requiring
replacement or fasteners requiring the use of thread locking compound or sealant
are identified in the service procedure. Do not use paints, lubricants, or
corrosion inhibitors on fasteners or fastener joint surfaces unless specified.
These coatings affect fastener torque and joint clamping force and may damage
the fastener. Use the correct tightening sequence and specifications when
installing fasteners in order to avoid damage to parts and systems.
- Tighten the door lock striker screws.
Tighten
Tighten the striker screws to 25 N·m (18 lb ft).
- Adjust door lock striker if required. Refer to
Door Lock Striker Adjustment
- Install the front and/or rear trim.