Starter Replacement RPO LS4

1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
2. Remove the starter solenoid BAT terminal nut (3) and remove the positive battery cable (2) from the starter motor.
3. Remove the engine harness terminal (4) from the starter motor.



4. Disconnect the starter motor electrical connector (1).
5. Remove the air cleaner assembly. Refer to Air Cleaner Assembly Replacement .



6. Remove the starter motor bolts and starter motor.

1. Position the starter motor to the engine.

Notice: Refer to Fastener Notice in the Preface section.

2. Install the starter bolts.

Tighten
Tighten the bolts to 50 N·m (37 lb ft).




3. Connect the starter motor electrical connector (1).



4. Install the engine harness terminal (4) to the starter motor.
5. Install the positive battery cable (2) and the starter solenoid BAT terminal nut (3) to the starter motor.

Tighten
Tighten the solenoid BAT terminal nut to 10 N·m (89 lb in).

6. Install the air cleaner assembly. Refer to Air Cleaner Assembly Replacement .
7. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .

Starter Replacement RPOs LZE/LZ4/LZ9

1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
2. Remove the front lower air deflector panel. Refer to Radiator Air Lower Baffle and Deflector Replacement .
3. Remove the torque converter cover. Refer to Torque Converter Cover Replacement .
4. Remove the starter solenoid BAT terminal nut (1) from the starter motor.
5. Remove the positive battery cable terminal (2) and engine harness terminal (3) from the starter.



6. Disconnect the starter motor electrical connector (3).



7. Remove the starter bolts.
8. Remove the starter.

1. Position the starter motor to the engine.

Notice: Refer to Fastener Notice in the Preface section.

2. Install the starter bolts.

Tighten
Tighten the bolts to 43 N·m (32 lb ft).




3. Connect the starter motor electrical connector (3).



4. Install the engine harness terminal (1) and positive battery cable terminal (2) to the starter. Ensure that the positive battery cable terminal anti-rotation feature is aligned correctly.
5. Install the starter solenoid BAT terminal nut (3) to the starter motor.

Tighten
Tighten the nut to 10 N·m (89 lb in).

6. Install the torque converter covers. Refer to Torque Converter Cover Replacement .
7. Install the front lower air deflector panel. Refer to Radiator Air Lower Baffle and Deflector Replacement .
8. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .