- Disable the inflatable restraint steering wheel module. Refer to Disabling the SIR System in SIR.
- Remove the upper and lower trim covers. Refer to Steering Column Trim Covers - Disassemble - Off Vehicle .
- Use the tilt lever to tilt the column in the UP position.
- Remove the tilt spring (1).
- Remove the spring guide (1) from the tilt spring (2).
Caution: This vehicle is equipped with a Supplemental Inflatable Restraint (SIR) System. Failure to follow the correct procedure could cause the following conditions:
• Air bag deployment • Personal injury • Unnecessary SIR system repairs • Refer to SIR Component Views in order to determine if you are performing service on or near the SIR components or the SIR wiring. • If you are performing service on or near the SIR components or the SIR wiring, disable the SIR system. Refer to Disabling the SIR System.
Caution: The tilt spring and the spring guide are under pressure. The tilt spring and the spring guide may become a projectile. Secure the spring with locking pliers during removal. Secure the spring with locking pliers during installation. Bodily injury may result during removal and installation of the tilt spring and the spring guide. Always use caution during removal and installation of the tilt spring and the spring guide.
| 4.1. | Pry the tilt spring up using a screwdriver until a bulge occurs and most of the tilt spring tension is removed. |
| 4.2. | Secure the tilt spring with locking pliers and continue prying until the tilt spring disengages from the post on the steering column support assembly (2) and the steering column tilt head assembly (3). |
