Tools Required

J 42562 Axle Removal Wedge

1. Remove the case extension housing. Refer to Case Extension Replacement .
2. Remove the left wheel drive shaft from the transaxle. Refer to Wheel Drive Shaft Replacement in Wheel Drive Shafts.



3. Rotate the differential carrier until the end of the output shaft can be seen and the differential pinion shaft (701) is in a horizontal position.
4. Place the J 42562 between the end of the output shaft and the differential pinion shaft.
5. Using a hammer, hit the end of the axle removal tool in order to compress the output shaft compression ring (512) and push the output shaft through the differential side gear.



6. Remove the differential carrier (700).
7. Using snap ring pliers remove the compression ring (512) from the output shaft.
8. Remove the output shaft through the left wheel opening.



9. Inspect the output shaft (510) for the following:

•	Stripped splines

•	A damaged retainer ring groove

1. Install the drive axle retainer ring (509) and the output shaft differential inboard snap ring (512) onto the output shaft (510).
2. Hold the front differential carrier (700) in place and carefully install the output shaft (510) into the transmission through the left wheel opening. Extend the output shaft through the differential side gear.
3. Install the left wheel drive shaft to the transaxle. Refer to Wheel Drive Shaft Replacement in Wheel Drive Shafts.
4. Install the case extension housing. Refer to Case Extension Replacement .